Page 47 - 2018-23
P. 47
理论与研究 于祥 等·NBR/BR 共混胶的性能预测研究
时间数据预测长时间性能。利用数据处理软件对表 8 3 结论
测试结果进行处理,以温度 10 000/T(开氏温度)与 (1)通过对扯断伸长率的预测可知,压缩永久变
lgt 作图,结果见图 9。 形保持率 P=0.6 时,NBR/BR 的保持率比纯 NBR 好,
即可以应用于扯断伸长率要求低,但是尺寸稳定好的
产品。
(2)通过对压缩永久变形的预测可知,NBR/BR
在 110℃以下时,表现出比纯 NBR 更好的耐压变性。
(3)通过对定伸应力的预测可知,当 50% 定伸应
力保持率临界值为 1.5 时,在高温下纯 NBR 的定伸应
力保持率比 NBR/BR 好,在低温时反之。
参考文献 :
[1] 肖琐,魏伯荣,杜茂平 . 橡胶加速老化试验及贮存期推算方
法 . 合成材料老化与应用,2007,36(1):40~43.
[2] 易军,刘海露,吴丝竹,等 . 基于 ArrheniuS 修止公式的橡胶
老化寿命预测 . 第八届全国橡胶业新材料技术论坛暨 2008 年
图 9 温度与时间对数关系图 橡胶助剂专业委员会会员大会 , 北京 ,2008,130~135.750.
[3] 胡文军,刘片芳,陈勇梅 . 橡胶的热氧加速老化试验及寿命预
利用一次函数拟合公式拟合表 8 中曲线,压缩永
测方法 . 橡胶工业,2004,51(10):620~624.
久变形保持率 P=0.6 时得到 : [4] Kenneth Gillen, Robert Bernstein, DoraK. Derzon. Sandia
纯 NBR 硫化胶的拟合方程 lgt=-1.89+0.15× National Laboratories, Albuquerque, USA. Evideneeofnon-
Arrhenius behaviour from laboratory aging and24-year field
10 000/T,校正系数 R=0.888,说明拟合很好。
aging of PolyehloroPrene rubbermaterials .15.June.2004.
得到 2# 硫化胶的拟合方程 lgt=-3.43+0.21× [5] Coons J E, MeKay M D, HamadaMS. A Bayesian analysis
10 000/T,校正系数 R=0.992 9, 说明拟合很好。 of theeompression SetAnd stress-strain behavior in a
thermally age dsilieone foam. Polymer Degradation And
通 过拟 合 曲 线可 以 看出, 压 缩 永久 变 形 保持 率
Stability,2006,91:18241836.
P=0.6 时,温度低于 110 ℃的情况下,NBR/BR 的 [6] Agarwal K, Prasad M, Chakraborty A, et al. Studies on phase
Lgt 高于纯 NBR,即 NBR/BR 的压变性能比纯 NBR morphology and thermo physical properties of nitrile rubber
blends[J]. J Therm Anal Calorim, 2011, 104:1 125~1 133.
好。
Performance prediction study of NBR/BR blended rubber
Yu Xiang, Lin Yao, Deng Tao
(Qingdao University of Science & Technology, Qingdao 266042, Shandong, China)
Abstract: The aging performance of the blended rubber at 80 ℃ , 100 ℃ and 120 ℃ for 1, 3, 5, 7 and 9
days was determined by accelerated aging test in hot oil. And the performance change rule of elongation
at break, modulus and compression set after aging were predicted. The results show that the elongation
retention rate of NBR/BR is better than that of pure NBR; Under the specific retention threshold, NBR/BR exhibits
better pressure resistance than pure NBR when the temperature is lower than 110 ℃ ; Under a certain critical
value of 50% modulus retention rate, the modulus retention rate of pure NBR is higher than that of NBR/BR at
high temperature.
Key words: NBR; BR; performance prediction
(R-05)
2018 第 44 卷 ·11·
年